|
 |
|
| |
 |
|
 |
CONNECTOR Development section |
| |
| - |
RF Connector |
| |
- MIL Spec : SMA, N, SMB, MCX Etc for High
frequency
- DIN Spec : 7/16, 41626 Etc.
- Various parts &
developed form |
| - |
RF Cable Assembly |
| |
 |
| |
|
|
|
MODULE Development section |
| |
| - |
Passive Module |
| |
Divider, Coupler, Arrestor, Attenuator Etc |
| - |
Active Module |
| |
LNA, Converter Etc |
| - |
Development |
| |
 |
| |
|
|
|
|
|
 |
|
|
CONNECTOR |
| |
| |
Used for RF equipment or connection
between modules, vertical section port and
has the good electronic, utensil, Environmental
characteristics |
| |
Type G2.9mm
- Used for Super High frequency range below
40GHz
LOCKING TYPE
- Is attached to the locking device
and does not separate from it below 4Kgf
power
SMA, N, SMB,
MCX etc.
- Connector usually used for High
frequency |
| |
 |
|
|
CABLE ASSEMBLY |
| |
 |
Is a connected product between
connector and cable, and used to Connect equipment,
module, port |
|
| |
|
|
RF MODULE |
| |
| - |
LNA (Low Noise Amplifier) |
| |
Used to improve the receiving sensitivity
by minimizing the noise of receiver of equipment |
| - |
COUPLER |
| |
Is attached to the locking device and does
not separate form it
below 4Kgf power |
| - |
DIVIDER |
| |
Distributes one input signal into at least
two same signals, amplitude and phase |
| - |
COMBINER |
| |
Used to combine more than two input signals
to the same amplitude and phase |
| - |
ARRESTOR |
| |
Is attached to vertical hem and used to
protect equipment from high voltage or high
current |
| |
 |
| |
|
|
|
|
|
|
